Flash programming for 2nd FPGA on Arria V GT FPGA Development Kit (DK-DEV-5AGTD7N)

Thanks for responding

I think I read that already, but I have not actually been able to try it because I don't have the board yet.

I am trying to confirm it does what I need before buying a $4,000 board.

However the procedure from the user guide on page 53 seems to only apply for FPGA 1:

The programming files used in the commands on page 53 are created with the commands on page 52.

The commands on page 52 again use the flash addresses given in table A-1 on page 51.

In table A-1 there are only the memory locations for the FPGA 1:

User hardware 2 at 0x02CA.0000

User hardware 1 at 0x0166.0000

Factory hardware at 0x0002.0000

selectable with PGM1 (S2)

The documentation doesn't seem to clearly state how to program FPGA2 permanently.