Forum Discussion
MSchi30
New Contributor
New ContributorFlash programming for 2nd FPGA on Arria V GT FPGA Development Kit (DK-DEV-5AGTD7N)
The user guide describes how to program the flash memory device for the 1st FPGA in Appendix A. However I cannot figure out how to do that for the 2nd FPGA. P.S. I cannot easily connect the board t...
MSchi30New Contributor
New ContributorI am referring to this eval board:
It has 2 FPGAs on it.
The flash device holds 2 hardware images for the 1st FPGA. Which one is loaded at power up is selectable with a switch.
However I don't see how to load the 2nd FPGA. I hope JTAG programming is not the only way to load the 2nd FPGA because that would not be permanent.
