Forum Discussion
NYup
New Contributor
New Contributorenable secure JTAG in max10 lockup board.
Error (209014): CONFIG DONE is FAILED to go high What is the problem? I am using Quartus version 18.0 on linux. FPGA MAX10 device number 10M08SAM156CBG I enable Secure JTAG with Intel provided In...
YuanLi_S_Intel
Regular Contributor
Regular ContributorSorry the document should be referring to this instead of AN556:
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf#page=53
NYupNew Contributor
New ContributorHello,
You said your board is working with secure Jtag. I asked you last week
if you will send me the QAR for your max 10 board.
I have not heard back from you. It will help me alot since I have been
stuck for months now.
Nhu-Ha Yup
Rajant Corporation
4505 E. Chandler Blvd. #250
Phoenix, AZ 85048
[email protected] <[email protected]>
P: 602-362-2150 x2216
