Forum Discussion

NYup's avatar
NYup
Icon for New Contributor rankNew Contributor
6 years ago

enable secure JTAG in max10 lockup board.

Error (209014): CONFIG DONE is FAILED to go high What is the problem? I am using Quartus version 18.0 on linux. FPGA MAX10 device number 10M08SAM156CBG I enable Secure JTAG with Intel provided In...
YuanLi_S_Intel's avatar
YuanLi_S_Intel
Icon for Regular Contributor rankRegular Contributor
6 years ago

Hi Nhu-Ha Yup,

Sorry for the late, WYSIWYG is an internal JTAG interface. It doesn't control CONF_DONE pin directly but if the configuration is working successfully, the CONF_DONE pin will be asserted.

Just would like to check, have you used our reference design and also the JAM file provided? Or you use your own and obtain the following error? Please let me know.

Just for your information, you can obtain the reference design at link below:

https://fpgacloud.intel.com/devstore/platform/15.0.0/Standard/max10-jtag-secure-unlock/

The steps to use the reference design is in this AN556:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an556.pdf

Thank You.

Recent Discussions