Forum Discussion

New Contributor

6 years ago

enable secure JTAG in max10 lockup board.

Error (209014): CONFIG DONE is FAILED to go high What is the problem? I am using Quartus version 18.0 on linux. FPGA MAX10 device number 10M08SAM156CBG I enable Secure JTAG with Intel provided In...

YuanLi_S_Intel

Regular Contributor

6 years ago

Hi Nhu,

This is weird. By right it should be able to program after you UNLOCK it. May i know, have you observed if "indicator" port is going HIGH? You may also refer to the steps to UNLOCK as shown at link below:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf (Page 58)

Thank You.

NYup

New Contributor

6 years ago

The indicator isn’t accessible on our system board . I will ask Bert our local FAE whose evaluation board is locked up to see what it is . Thanks Nhu-Ha

Forum Discussion

enable secure JTAG in max10 lockup board.

Recent Discussions

AGILEX 5 cvp mode

Arrow AXE5 Eagle Board JTAG issue

PDN file and PCB decoupling

PCIe Example Design for Arrow EAGLE Board

CXL 2.0 support on the NEW Agilex™ 7 FPGA I-Series Development Kit (2x R-Tile and 1x F-Tile)