Done: A command-line script for reading current values using the Power Monitor

Hi all,

I've created a script to read the current values from a command line, using system-console. It's been tested with the cyclone iv gx transceiver starter kit and cyclone iv gx fpga development kit boards, but it should be easy to adapt to other platforms.

https://github.com/ricardo-jasinski/power_monitor_automation

Here is a sample output:

Board detected: Cyclone IV GX Transceiver Starter Kit
Current readings:
2.5_VCC              0.041 A    Rail 8    0xbf 0x0
1.2_VCCL_GXB         0.068 A    Rail 1    0x3f 0x1
2.5_VCC_GXB          0.057 A    Rail 2    0xa 0x1
2.5_VCCIO            0.006 A    Rail 3    0x1e 0x0
1.2_VCCINT           0.166 A    Rail 4    0xe 0x3
1.2_VCCD_PLL         0.033 A    Rail 5    0x9d 0x0
open                 0.004 A    Rail 6    0x11 0x0
open                 0.005 A    Rail 7    0x16 0x0

Please let me know if it works in other environments!