Forum Discussion

VROGE2's avatar
VROGE2
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

DE10-Nano Stops after roughly 30 seconds

I am running a program on my DE10-Nano which takes the 50MHz clock and Converts it to a 2MHz Square wave. I then output the 2MHz square wave over a GPIO pin and I am reading it with an oscilloscope. ...
Vicky1's avatar
Vicky1
Icon for Regular Contributor rankRegular Contributor
6 years ago

Hi,

May I know any update?

Regards,

Vicky

  • VROGE2's avatar
    VROGE2
    Icon for Occasional Contributor rankOccasional Contributor
    6 years ago

    Sorry for the late reply I have been away from the project.

    The green LEDs would be only remain lit until the board stopped running my code.

    I was able to solve the problem by changing the MSEL pins to the AS configuration. Was that the correct way to go about solving to problem or did I change some other settings in doing that?