Forum Discussion

VROGE2's avatar
VROGE2
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

DE10-Nano Stops after roughly 30 seconds

I am running a program on my DE10-Nano which takes the 50MHz clock and Converts it to a 2MHz Square wave. I then output the 2MHz square wave over a GPIO pin and I am reading it with an oscilloscope. ...
Vicky1's avatar
Vicky1
Icon for Regular Contributor rankRegular Contributor
6 years ago

Hi,

  1. Please provide the status of LEDs( names & observation) for initially 30 seconds & after 30 seconds.
  2. Try to check by programming with another GPIO pin or check with another program, simply ensure that board is not faulty, if possible check with another DE10-Nano board.
  3. Please check the Quartus log/message window for any critical warning.

Regards,

Vicky