Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

DE0 connector locations in layout, daughter card development

There is great general information in the readily available university dev boards documents, but I would like to build a daughter card that mates to the DE0. It would be much easier to start with th...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Ok. We had the following part number in the bom for the two 40 pin headers

SSM-120-L-DV-LC SSM-120-L-DV-LC Samtec

RECPT 2X20 .100" PITCH W/ LOCKING CLIPS

They are aligned vertically, and are space 800 mils apart horizontally, we had the deepest 42 mils from the back edge of the board. The board was 2200 mils wide and fit within the Plexiglas cutout on the DE0..

(With the connectors centered in the 2200 mils)

Pete