Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

CYCLONE III DEV Board Not working

I bought CYCLONE IIII DEV Board recently, and followed the manual carefully, but just could not get the basic examples and DEMO to work. Following are my problems:

1) after connect to Ethernet network, the TOP LCD in the board didnt show any IP address

2) trying to run BoartTestSysteme.exe, all the tabs for GPIO, SDRAM and etc are gray, nor the configure menus , all show gray, nothing is working

3) if I switch the rotary switch to "1", then power up, DZ21 error will lit up, nothing else will happen

Does the board go bad?

Thanks for the help!

Hana

4 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    13 years ago

    --- Quote Start ---

    What does the supplier say?

    --- Quote End ---

    they didn't reply anything back to me. I bought this board from Bit-ec, in Europe, they didn't pickup the phone, they didn't reply me the email. When I ordered the board, their email were responded back very quick.
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    13 years ago

    Maybe programm is not downloaded.

    BTW, how much do you pay for this DEV board?