Forum Discussion

New Contributor

7 years ago

Cyclone 10GX JTAG Programming

Hi, I am using Cyclone 10GX in one of my design. When I started testing my board, JTAG was not functioning properly. I could program Cyclone10 through JTAG at 1MHz but not beyond that. I tried diffe...

AnandRaj_S_Intel

Regular Contributor

7 years ago

Hi Bhagavath,

Please try setting mentioned in below link also regenerated the programming file. (Delete all temporary folders)

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/component/2018/how-do-i-enable-micron-s-mt25q-support-for-eol-of-epcq---256mb--.html

Regards

Anand

KBhag3

New Contributor

7 years ago

Dear Anand,

I tried this but status is same.

Best regards,

Bhagavath

Forum Discussion

Cyclone 10GX JTAG Programming

Recent Discussions

SyncE clock as the reference for DDR, HBM, and FPGA control interfaces in the Agilex M-Series design

PCIe Root Complex on DK-A5E013BM16AEA

Agilex™ 7 FPGA M-Series Development Kit_HBM2e Edition_REVB2_Altera

Agilex 7 R-Tile PIPE Direct endpoint receives Set_Slot_Power_Limit, but no Config TLPs

R-tile CXL base hard IP example for the Agilex 7 M-series Dev Kit (DK_DEV_AGM039EA) does not work