Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Cyc III Starter Kit Issue: was working, now getting msg "could not estab JTAG conn"

Have been using Cyc II Starter Kit for an in house prototype design successfully for at least a year on an old Windows XP computer with Quartus II Web edition 12.1. Was very simple to operate, opened programmer,clicked auto detect and my board/chipset would load. I added my .sof file and everything ran perfectly.

All of a sudden the computer is no longer recognizing the starter kit board/chipset. If I rebooted and changed USB ports a few times I could get it to load eventually, now, not at all. I then tried the board on a different computer it had worked on previously with no success. I ordered a brand new starter kit and I'm still having the same issue.

"Could not establish JTAG connection between board and control panel application"

No sure why it would work for a year without a hitch and all of a sudden, 2 different boards are not recognized by 2 different computers. Any assistance would be appreciated.

1 Reply

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    As I understand it, you are using Quartus II web edition. Have you had a chance to try with subscription edition to see if there is any difference? By the way, is it that the error message "could not estab JTAG conn" occur when you open BTS? If yes, probably you could try with normal JTAG using programmer to see if can detect device just to verify if it is BTS issue.