Forum Discussion
APaci1
Occasional Contributor
Occasional ContributorConnecting 2 TSE (with micrel PHY) each other: Link down
i! I have my Arria10 custom board 2x TSE-PHY MICREL-Ethernet Ports A,B A,B linked to PC NIC works fine (I send and transmit frames from PC to TSE and vice-versa) , I see 100 Mbps, Full Duplex, A...
SengKok_L_Intel
Regular Contributor
Regular ContributorI have run the simulation and confirm the address filtering is working fine from my site.
Could you please try the following setting, and read back the register to confirm?
- Address 2 command_config = 0x048002b
- Address 3 MAC_0 = 0x22334450
- Address 4 MAC_1= 0x 0000EE11
Could you please also refer to the link below, section 5.3.1 and follow the recommended initialization sequences?
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_ethernet.pdf
