Forum Discussion

APaci1's avatar
APaci1
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

Connecting 2 TSE (with micrel PHY) each other: Link down

i! I have my Arria10 custom board 2x TSE-PHY MICREL-Ethernet Ports A,B A,B linked to PC NIC works fine (I send and transmit frames from PC to TSE and vice-versa) , I see 100 Mbps, Full Duplex, A...
SengKok_L_Intel's avatar
SengKok_L_Intel
Icon for Regular Contributor rankRegular Contributor
7 years ago

It seem like this is your primary mac address 0xFFEEDDBBCCAA. ​Did you enable the supplemental MAC unicast address? If yes, please configure the supplemental MAC address same as primary address for testing purpose. Could you please provide a signal tap or waveform on the Receiver Avalon ST interface & GMII interface to confirm the MAC address you received is expected but does not get filter out.