Connecting 2 TSE (with micrel PHY) each other: Link down

Hello! Sorry for my delay, but we have a bunch of damned word to find 1000 mbps issue on PHY Microchip. Problem was hardware: some surge protecions on line side make 1000mbps connection impossible. After dismantle these components now both Ethernet connections on my custom board runs at 1000 mbps (!)

Now I'm fighting with TSE_MAC filtering problem. I set PROMISE_EN=0 and TSE_CRTL_FRM_ENA=1,

I set primary TSE Mac only. When it runs, on "user side" I see that Frames arrives with any Mac D , tse should filters only MAcD=Mac TSE .... I believe... but filter doesn't run. :-(((

Tomorrow I'll check better!!! Probably I fails or omits another setting on TSE to activate this filter