Forum Discussion

Vivek_tiwari's avatar
Vivek_tiwari
Icon for New Contributor rankNew Contributor
4 years ago

Configuration Error in Stratix 10 After programming .jic file

I Tried programming Stratix 10 FPGA kit with .jic file using jtag msel pins as MSEL[2:0] as 111 and it was programmed successfully configuration error led D3 was still glowing red after that i power ...
JohnT_Altera's avatar
JohnT_Altera
Icon for Regular Contributor rankRegular Contributor
4 years ago

Hi,


Could you manually probe nStatus and nConfig pin? The reason is that it seems like the configuration has not performed.


May I know if this is your own board or development kit?


  • Vivek_tiwari's avatar
    Vivek_tiwari
    Icon for New Contributor rankNew Contributor
    4 years ago

    Hi,

    I don't know how and where can I probe/find these pins.

    I am using the development kit.