Forum Discussion

ocan's avatar
ocan
Icon for New Contributor rankNew Contributor
7 years ago

Conf done pin failed to go high in device1

Hi, I have a problem when my card is programming with JTAG. I opened with Quartus Prime 15.1 . I want to program with JTAG interface. But, Sometimes I click start button so I looked program fail...
ocan's avatar
ocan
Icon for New Contributor rankNew Contributor
7 years ago

​Firstly, I am sure all the power is on stable and the configuration is idle. I want to program FPGA with .sof file. But sometimes I did not programmmed, What do u think of can my altera blaster's velocity affect my fpga programming badly ???

Sometimes I the first clicked start program so ıt was succesfull.

If all the power is not stable, MYfirst click would not be succesfull.

what do u recommend with me ?

thanks a lot ...