Forum Discussion

KSmil's avatar
KSmil
Icon for New Contributor rankNew Contributor
7 years ago

"CONF_DONE pin failed to go high in device 1" - Arria 10 FPGA Dev Kit

I have been testing a design on an Arria 10 FPGA Dev Kit which uses the FMCA connection to send/receive signals between a couple of other designs on other development cards. The Arria 10 no longer l...
KSmil's avatar
KSmil
Icon for New Contributor rankNew Contributor
7 years ago

​Hi Nooraini,

The aria 10 still does not configure when the settings are set to default. The default factory image is still stored in the flash, but even setting all the settings back to default (as per the user guide) the Arria 10 cannot configure with this image.

Thanks,

Karl