Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

CONF_DONE in failed to go high jtag

With the Cyclone III starter board my USB-JTAG pod fails to configure the board. The error in the Quartus message window is: Error (209014): CONF_DONE pin failed to go high in device 1 The...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

The knock off pod works!!

It is slower, a bit crashy, and feels warm. But that is so much better than the results I was getting from my other pod, which is apparently broken.

For the long term I think I will get a better pod.

Thank you for your help!

Steve