Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

CONF_DONE in failed to go high jtag

With the Cyclone III starter board my USB-JTAG pod fails to configure the board. The error in the Quartus message window is: Error (209014): CONF_DONE pin failed to go high in device 1 The...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

--- Quote Start ---

At a different location someone got the system working with a revC pod. I have ordered one from Amazon ($25!). Hopefully it will start working for me with the new usb blaster.

--- Quote End ---

Can you post a link to this. The price sounds too low to be a real USB-Blaster. Its likely a knock-off, so it might work, but perhaps be slower than a real USB-Blaster. The $50 devices from Terasic are 'authentic' (approved by Altera) and work great.

Cheers,

Dave