Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

CONF_DONE in failed to go high jtag

With the Cyclone III starter board my USB-JTAG pod fails to configure the board. The error in the Quartus message window is: Error (209014): CONF_DONE pin failed to go high in device 1 The...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

--- Quote Start ---

I could load the software on a different PC (use XP instead of Win7). Is there a reasonable chance that could be an issue?

--- Quote End ---

Loaded the software on XP - everything behaves the same as it did on Win7-32bit.

Possibly its the pod? But it passed the jtag IDCODE tests...