Forum Discussion

lisheng's avatar
lisheng
Icon for New Contributor rankNew Contributor
5 years ago

Cannot connect Cyclone® 10 GX Development Kit Board

I bought A new DK - DEV - 10 cx220 - A, use website kit through the onboard Micro - USB connection is not on the board, dial the code switch is the default state, use multimeter to check, found that ...
AR_A_Intel's avatar
AR_A_Intel
Icon for Super Contributor rankSuper Contributor
5 years ago

Hello,

Thanks for update. FYI, the board team stop providing the source file, we no longer provide the source code U2 chip (Intel MAX 10 FPGA Power Manager) file of system for any Intel Development Kit board. Apologize for any inconvenience caused. For pin configuration you can check in schematic diagram and board layout pcb Cadence .OLB file. Please find package here https://www.intel.com/content/www/us/en/programmable/support/support-resources/download/board-layout-test/pcb/pcb-cadence.html?elq_cid=4171900&erpm_id=2892549


TRAN_HIEU_007's avatar
TRAN_HIEU_007
Icon for Occasional Contributor rankOccasional Contributor
5 years ago

You can provide me *.sof or *.pof file for the U2 chip. I am developing hardware use the chip Cyclone10GX base designed of Cyclone® 10 GX Development kit. Thank you so much!

  • AR_A_Intel's avatar
    AR_A_Intel
    Icon for Super Contributor rankSuper Contributor
    5 years ago

    Hi,

    You could refer to attachment .sof file. Thanks

    • TRAN_HIEU_007's avatar
      TRAN_HIEU_007
      Icon for Occasional Contributor rankOccasional Contributor
      5 years ago

      Thank AabdRahman for the reply! Are you sure this is a file for U2 (SYS MAX 10) in Cyclone 10GX deverlopment kit?