Forum Discussion

AKAYA's avatar
AKAYA
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

can we access a specific page of the flash memory to store certain code?

using MAX10 fpga. i need to create a boot program. The boot code need to be stored to a specific location and application code in other location. The boot code need to be wriiten in a specific page o...
Nooraini_Y_Intel's avatar
Nooraini_Y_Intel
Icon for Frequent Contributor rankFrequent Contributor
7 years ago

Hi Akaya,

You can still access the UFM block independently such as UFM0 and UFM1/2 base on the address of the sector. As long you have perform erase and un-protect the sector UFM0 or UFM1 or UFM2 , then you can set the address that you want to write the data. The address of each memory block is shown in the Address Mapping of the On Chip Flash IP.

Regards,

Nooraini

  • AKAYA's avatar
    AKAYA
    Icon for Occasional Contributor rankOccasional Contributor
    7 years ago

    thanks for the reply

    But we need to access a single page of the sector and not the entire sector at a time.

    erasing the page can be done. but can we write into a single page?

    the above image is the example operation which need to be performed. is it possible?