Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

BeMicro FPGA-based MCU Evaluation Board

This is the new BeMicro FPGA-based MCU Evaluation Board thread. Please post your questions and comments within this thread. Documentation and purchasing information can be found at www.arrow.com/bemi...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

I did not have any issues with installing the BeMicro-SDK under Windows 7.

I did however have version 10.1sp1 installed and then 11.0sp1 and then 11.1sp1 (these were the full subscription edition, but both 32-bit and 64-bit versions get installed and they work ok). I think there was an issue with the 11.0 drivers, which is why I said look at the threads for USB-Blaster install issues. Like this:

www.alteraforum.com/forum/showthread.php?t=33097

The BeMicro-SDK USB device IDs (under device manager) are VID 09FB, PID 6001, i.e., they have the ID of a standard USB-Blaster.

I'd recommend installing at least the 11.0 service pack, if not just upgrading to 11.1sp1.

Cheers,

Dave