Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorBeMicro FPGA-based MCU Evaluation Board
This is the new BeMicro FPGA-based MCU Evaluation Board thread. Please post your questions and comments within this thread. Documentation and purchasing information can be found at www.arrow.com/bemi...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- Hi I was wondering if anyone here that's been using their bemicro has made any use of the 80 pin edge connector? Would you know of an 80 pin connector that would slip onto the end of the bemicro from which I could run wires from? I would like to run pwr and assorted inputs to the brd through this connector and run control signals out. Thanks... Mike --- Quote End --- The mating connector for the card-edge on the BeMicro is the MEC6 series from Samtec: http://www.samtec.com/productinformation/technicalspecifications/overview.aspx?series=mec6-ra You can also buy a prototyping board from Hitex for the BeMicro: http://www.ehitex.de/p_info.php?products_id=311 Jake
