Forum Discussion

Contributor

5 years ago

Arria10SOC Dev Kit Board: Updating EPCQL1024 show “209012 Operation Failed”

We have 2pieces of Arria-10-SOC-development-kit board from Intel. WE tried to update the on-board EPCQL1024 flash.The detailed steps as following: 1) Switch On board's “SW4 Bit-3" as High "1", ...

JET60200

Contributor

5 years ago

attached is my Quartus Console showing this ERROR - " 209012 Operation Failed " , Hope helps urgently.

ShafiqY_Intel

Frequent Contributor

5 years ago

Hi 3000021845821.562225903895492E12 ,

Can you kindly try to reduce your TCK frequency to 6 MHz?

Below link is the command to change TCK frequency (on page 14= 2.8. Changing the TCK Frequency)

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_usb_blstr_ii_cable.pdf#page=14

Kindly try it out with your design and let me know the result.

Thanks

Forum Discussion

Arria10SOC Dev Kit Board: Updating EPCQL1024 show “209012 Operation Failed”

Recent Discussions

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector