Forum Discussion

Occasional Contributor

6 years ago

arria 10 SoC boot

Customer Arria 10 SoC board fail to boot. It shows error message ERROR(CMD256-TAD10-NAL18) fromDS-5 debugger. ERROR(CMD256-TAD10-NAL18): ! Unable to display contents at location "S:0xFFFF000C" !...

AnilErinch_A_Intel

Frequent Contributor

6 years ago

Hi ,

Hope you are doing fine

Please refer to the similar issue and it mentions about the changes to be done to the scatter file and other possible issue scenarios.

https://community.arm.com/developer/tools-software/tools/f/armds-forum/12152/ds-5-bare-metal-wait-error-after-run-debug

Please let us know whether it helps.

Thanks and Regards

Anil

Forum Discussion

arria 10 SoC boot

Recent Discussions

Agilex™ 7 FPGA M-Series Development Kit_HBM2e Edition_REVB2_Altera

Agilex 7 R-Tile PIPE Direct endpoint receives Set_Slot_Power_Limit, but no Config TLPs

SyncE clock as the reference for DDR, HBM, and FPGA control interfaces in the Agilex M-Series design

R-tile CXL base hard IP example for the Agilex 7 M-series Dev Kit (DK_DEV_AGM039EA) does not work

PCIe Root Complex on DK-A5E013BM16AEA