Forum Discussion

New Contributor

9 months ago

Arria 10 GX CPU Reset Pulled Low Despite 1.8V Pull-Up

I am using the Intel Arria 10 GX development board. For the past two days, we have been troubleshooting an issue where the CPU reset signal is being pulled low, even though it has a 1.8V pull-up. Des...

Board Debug

AqidAyman_Altera

Regular Contributor

9 months ago

May I know if you are referring to CPU rest push button (S4) as in below link?

https://www.intel.com/content/www/us/en/docs/programmable/683526/current/board-overview.html

Or the CPU_RESETN from MAX V CPLD System Controller?

https://www.intel.com/content/www/us/en/docs/programmable/683526/current/max-v-cpld-system-controller.html

Forum Discussion

Arria 10 GX CPU Reset Pulled Low Despite 1.8V Pull-Up

Recent Discussions

Stratix 10 Development Kit HiLo connector

Stratix 10 FPGA Dev Kit VCCIO_FMC voltage issue

Mandelbrot viewer on Cyclone V - Platform Designer layout

Failed to get MAX10 Triple Speed Ethernet example design to compile

A question about reading the configuration space of the R-Tile PCIe IP EP