Forum Discussion

nhadzic's avatar
nhadzic
Icon for New Contributor rankNew Contributor
1 year ago

Apparent size limit for "User hardware1" image on Stratix 10 GX FPGA L-Tile board

I am using a Stratix 10 GX FPGA L-Tile board (DK-DEV-1SGX-L-A) and I am burning the binary image to the "User hardware1" section of the on-board flash. So far, the device utilization has been under 2...
Fpga Devkit
NurAiman_M_Intel's avatar
NurAiman_M_Intel
Icon for Super Contributor rankSuper Contributor
1 year ago

Hi,


Apologize for the delay in response.


You may check below,


Ensure that the flash partitioning is correctly configured. The flash might be partitioned for multiple purposes (e.g., "User hardware1" and "User hardware2"), and it's possible that the image is being placed in the wrong section or that the wrong section is being used to boot. -I think this might be the same as what you suspected


Action: Verify the flash section configuration using Quartus' Flash Programmer tool. Ensure that the "User hardware1" section contains the valid bitstream (SOF/POF image).


Regards,

Aiman