Forum Discussion
Humusk
New Contributor
New Contributor88E1111 is not working properly in MAX 10 Development Board.
Hello, I'm working with a custom IP core that works as an Ethernet stack. This stack has been used in the Cyclone 10 Evaluation Board without problems. We are migrating to the MAX 10 and I'm trying...
SengKok_L_Intel
Regular Contributor
Regular ContributorHi Gerald,
You can refer to the link below for the MAX10 TSE IP RGMII design example, you can use it as a starting point to debug your custom IP or Stack.
https://fpgacloud.intel.com/devstore/platform/18.0.0/Standard/max-10-single-port-triple-speed-ethernet-and-on-board-phy-chip-design-example/
Regards -SK
