Forum Discussion

WXu001's avatar
WXu001
Icon for New Contributor rankNew Contributor
6 years ago

5SGXMA5K3F40C2LN

​For this parts, through schematic confirm GA1T. AR10 & AR13 to GND should be greater than 200OHM ,Use multimeter measured about 60OHM.
Deshi_Intel's avatar
Deshi_Intel
Icon for Regular Contributor rankRegular Contributor
6 years ago

Hi,

Are you requesting failure analysis support for this suspected failure FPGA device here ?

Can you explain further on the FPGA failure symptom ?

  • How many failure FPGA devices here ?
  • Is this new prototype project or mature production project ?
  • Kindly clarify on the FPGA failure pins location again.
    • GA1T doesn't look like FPGA pin location. What's GA1T ?
    • Does AR10 and AR13 refer to FPGA pin location and you are facing pin short condition here ?
  • Under what kind of production testing that you observe this failure ?

Thanks.

Regards,

dlim