Forum Discussion

scali's avatar
scali
Icon for New Contributor rankNew Contributor
5 years ago
Solved

cannot run on fpga hardware

Hello, I've recently noticed that programs previously running on the fpga hardware are no longer working. I've also tried to recompile but I get the same problem. Here's the message I receive f...
  • scali's avatar
    scali
    5 years ago

    Hi.

    Now it seems to work. I didn't make any change.

scali's avatar
scali
Icon for New Contributor rankNew Contributor
5 years ago

Hi.

Now it seems to work. I didn't make any change.

  • Mickleman's avatar
    Mickleman
    Icon for Occasional Contributor rankOccasional Contributor
    5 years ago

    Thanks

    You are right. It now works for me again. I think the problem was that the qsub was not choosing nodes correctly. The nodes it chooses now are different and have the FPGA hardware installed.

    Regards

    Marcus

    • adarsh_m's avatar
      adarsh_m
      Icon for New Contributor rankNew Contributor
      5 years ago

      hello Is it working fine , I am still getting errors while using Opencl kernel on FPGA it mostly gives segmentation error 139

  • adarsh_m's avatar
    adarsh_m
    Icon for New Contributor rankNew Contributor
    5 years ago

    is it working now i am still facing such issues