New ContributorHi,
I installed the new Quartus Pro 20.1 and I set the Intel HLS variables (source init_hls.sh) but the i++ command is not found. The problem is on my local PC and in IntelDevCloud.
Could you please help me to solve this issue?
Thanks in advance.
Frequent ContributorHi
please look in to the directions given in below link.
https://www.intel.com/content/www/us/en/programmable/documentation/ewa1462479481465.html
Did you install the HLS compiler package from the below link
https://www.intel.in/content/www/in/en/software/programmable/quartus-prime/hls-compiler.html
Also can you post the output of source init_hls.sh.
Thanks and Regards
Anil
Frequent ContributorHi
Please let us know whether the below instructions.
"please look in to the directions given in below link.
https://www.intel.com/content/www/us/en/programmable/documentation/ewa1462479481465.html
Did you install the HLS compiler package from the below link
https://www.intel.in/content/www/in/en/software/programmable/quartus-prime/hls-compiler.html
Also can you post the output of source init_hls.sh. "
"
was helpful in resolving the issue.
Thanks and Regards
Anil
