Forum Discussion

AAhsan's avatar
AAhsan
Icon for New Contributor rankNew Contributor
3 years ago

Cyclone 10 GX Dev Kit FPGA SYS Max 10 Programming Using USB

Hi, I have Cyclone 10 GX Dev Kit FPGA and I am using example design systemmax10 project to configuration of temperature sensor over i2c bus , I try to read data from EM2130 but find out EN_GROUP...
AAhsan's avatar
AAhsan
Icon for New Contributor rankNew Contributor
3 years ago

HI,

Thanks for your response.

With USB blaster Auto Detect we are getting following.

As our understanding this is CFG MAX 10 Devices , as for to control EN_GROUP we need Sys MAX10. Please correct if our understanding is not right ?

Our Switch Configurations

And Signal we want to control (Sys MAx 10)

But in example design these pins are connected to PFL ( which is connected to CFG MAX 10 Device)

So, from that our understating is Example design is For CFG MAX 10 Device. we have other project of Sys MAx10 but as mention above JTAG chain only give above device to program.

Waiting for you response.