Forum Discussion

scali's avatar
scali
Icon for New Contributor rankNew Contributor
4 years ago
Solved

cannot run on fpga hardware

Hello, I've recently noticed that programs previously running on the fpga hardware are no longer working. I've also tried to recompile but I get the same problem. Here's the message I receive f...
  • scali's avatar
    scali
    4 years ago

    Hi.

    Now it seems to work. I didn't make any change.

Mickleman's avatar
Mickleman
Icon for Occasional Contributor rankOccasional Contributor
4 years ago

Thanks

You are right. It now works for me again. I think the problem was that the qsub was not choosing nodes correctly. The nodes it chooses now are different and have the FPGA hardware installed.

Regards

Marcus

adarsh_m's avatar
adarsh_m
Icon for New Contributor rankNew Contributor
4 years ago

hello Is it working fine , I am still getting errors while using Opencl kernel on FPGA it mostly gives segmentation error 139