Most RecentI forgot to connect the CONF_DONE pin to a pull-up so it's floating. This results in that the board will not start-up. Any workaround?Hello Does the Hot socketing feature replace the use power up sequence? Are they dependent on each other?Bank 5A can't be assigned to 1.8V levelHow can I use the HDMI Tx port on Arria V GX Starter kit?Does Platform Designer work on Ubuntu 18.04?Where is the 322.265625 MHz clock on the Arria 10 SoC Dev Kit?[intel] - SX10 versus SX5 dma performanceGerber files for EN29A0QIHow to measure the fpga power alone from the external pin?About using the RZQ for termination calibration
