AGofs
Occasional ContributorJoined 7 years ago
User Profile
Occasional Contributor
User Widgets
Contributions
Quartus 18.1 Lite installation on laptop
Good afternoon! I'm trying to install Quartus 18.1 Lite on my laptop, but installation lasts for too much time and never completed. The Laptop has Windows 7, SP1, 64-bit system, frequency of 2.7 GHz and 4 GB RAM. More than 100 GHz of the disk is free. Why installation process stuck in? What can I do in order to complete the process of installation?825Views0likes6CommentsRe: Quartus II 18.1 lite edition in system memory editor
Good morning, I've tried to program my device from JTAG Configuration section of the ISME- sometimes it programs my device properly, but rarely (approximately 1 from 10 trials). "programs my device properly"- means I've seen rising at the current consuming. all another trials- any rising at the current consuming after device has been programmed. in addition, when I'm using an "auto-detect" option at the programmer- it also programs my device properly, but not every time (approximately 1 from 4 trials).2KViews0likes0CommentsQuartus II 18.1 lite edition in system memory editor
Good afternoon , I'm working with 18.1 lite edition with my new FPGA design. I can program FPGA successfully, and then I'm opening InSystem Memory Editor . JTAG ready and USB-Blaster found. I would expect to receive a lot of InSystem Memory Editor instances ( as planned at the my design). but I'm getting warning :"No instance found". There not a matter of the USB-blaster or SW, because I've got InSystem Memory Editor instances at the previous FPGA design with same USB-Blaster and same SW. Where is a problem?2.1KViews0likes10Comments