Occasional Contributor
Occasional ContributorThanks for reply. I don't make any project. I just open the Modelsim, write a TCL do file, change to that directory, run that TCL script, and that's it. That compiles and launches the simulations.
Super ContributorI am using Modelsim -Intel FPGA Edition and just like you did, File > Change Directory to where the script file is e.g. example.do, run do example.do and execute the simulation. I am using the example design from the link I provided in my previous response.
In my case, I do not saw the wlfxxxx file generated though, only vsim.wlf is generated. Perhaps you may file a case to the Mentor forum for a solution?
Best Regards,
Richard Tan
p/s: If any answer from the community or Intel support are helpful, please feel free to give Kudos.
