Forum Discussion

ZZhan108's avatar
ZZhan108
Icon for New Contributor rankNew Contributor
6 years ago

Problem on downloading bitstream to a Stratix 10 MX board

Hi all, Now I'm trying to programming the Stratix 10 MX board with a simple test example (4-bit counter). Following are my hardware and software info: Software: Quartus Prime Pro 19.3 Hardware: St...
JohnT_Altera's avatar
JohnT_Altera
Icon for Regular Contributor rankRegular Contributor
6 years ago

Hi,

May I know if you can directly program the FPGA when you start powering up your PC?

  • ZZhan108's avatar
    ZZhan108
    Icon for New Contributor rankNew Contributor
    6 years ago

    Thanks for your reply!

    No, I can't. What I tried before is directly programming the FPGA through the JTAG port (J15 on the Stratix 10 MX board). And I got the error saying "Synchronization failed. Configuration error" (The figure I attached in my original post shows more detail about the error message).