Forum Discussion
Chloé_Russell
New Contributor
New ContributorEPCQL controller I Quartus version 16.0
Hello, I am trying to access in read and write my EPCQL-1024 from simple soft running in NIOSII. I have the Altera Serial Flash Controller I configured in QUAD mode connected from its avl_csr and a...
Chloé_RussellNew Contributor
New ContributorHi,
Thank you for your reply.
Unfortunately, I’m using the USB Blaster <https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_usb_blstr.pdf> https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_usb_blstr.pdf. I assumed that its frequency is not configurable, although I tried to set it to 6M I’ve got the following messages (I tried some commands, excuse me for being a newbie on this):
To answer to your first question, my EPCQ controller is correctly set to the QUAD mode:
Best Regards,
CR
