Forum Discussion
HUl_H
New Contributor
New ContributorEnabling FPGA2HPS Bridge in Uboot Hangs the Kernel
I am using Cyclone V SOC on De10 Nano kit. I have added Frame Reader IP in QSYS to HPS which uses FPGA2HPS bridge. I am programming FPGA via Uboot. When Uboot loads the RBF file and run "bridge_enabl...
YoshiakiS_Altera
Occasional Contributor
Occasional ContributorPlease confirm rstmgr(0xffd0501c) register value after executing bridge_enable_handoff script.
Bit 2 should be ‘0’. If it is ‘1’, FPGA2HPS bridge is still reset state.
HUl_HNew Contributor
New ContributorHow can i read the value of HPS registers from Uboot console?
"md.1 0xffd0501c"
???
