Forum Discussion

Mikhail_a's avatar
Mikhail_a
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

Building Yocto for FPGA boot first config on Agilex 7

Hello. I work with Intel Agilex ® 7 FPGA I-Series Transceiver-SoC Development Kit and AGIB027R31B1E2VR0 device. I need to build rootfs image. I've tried a guide I'd found on rocketboards (https://ww...
Jeet14's avatar
Jeet14
Icon for Frequent Contributor rankFrequent Contributor
3 years ago

Hi,


Please follow the below link on Build SD Card Image-

https://www.rocketboards.org/foswiki/Documentation/BuildingBootloaderAgilex7#Boot_from_SD_Card_Example


In this above link it guide us on sd card image creation with multiple files like- u-boot.itb, Image, socfpga_agilex_socdk.dtb, ghrd.core.rbf.


In you case while creating SD card image don't include the .rbf file. and when you board booted up at u-boot run the fpga load command to configure the bitfile.


Regards

Tiwari



Mikhail_a's avatar
Mikhail_a
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

Hello Tiwari

Thank you for this link. I'm going to try it and see if it works for me.