Forum Discussion
Mikhail_a
Occasional Contributor
Occasional ContributorBuilding Yocto for FPGA boot first config on Agilex 7
Hello. I work with Intel Agilex ® 7 FPGA I-Series Transceiver-SoC Development Kit and AGIB027R31B1E2VR0 device. I need to build rootfs image. I've tried a guide I'd found on rocketboards (https://ww...
Jeet14
Frequent Contributor
Frequent ContributorHi,
Are you looking for when board boots up from the SD card, it only runs the uboot and kernel and it should not load bitfile while booting?
Regards
Tiwari
Mikhail_aOccasional Contributor
Occasional ContributorHello!
Yes this is exactly what i'm looking for as at the moment of booting from SD card I already have the FPGA configured.
