Forum Discussion

Mikhail_a's avatar
Mikhail_a
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

Building Yocto for FPGA boot first config on Agilex 7

Hello. I work with Intel Agilex ® 7 FPGA I-Series Transceiver-SoC Development Kit and AGIB027R31B1E2VR0 device. I need to build rootfs image. I've tried a guide I'd found on rocketboards (https://ww...
Jeet14's avatar
Jeet14
Icon for Frequent Contributor rankFrequent Contributor
3 years ago

Hi,


Are you looking for when board boots up from the SD card, it only runs the uboot and kernel and it should not load bitfile while booting?


Regards

Tiwari


  • Mikhail_a's avatar
    Mikhail_a
    Icon for Occasional Contributor rankOccasional Contributor
    3 years ago

    Hello!

    Yes this is exactly what i'm looking for as at the moment of booting from SD card I already have the FPGA configured.