Forum Discussion

frank2597's avatar
frank2597
Icon for New Contributor rankNew Contributor
3 years ago
Solved

Verilog: Attempting to make a signal high for 5 clock cycles and then remain low

Hello, I am trying to make the signal called ld_tx_data_scope a value of 1 after the first 5 positive edges and remain high for 5 positive edges and then have it go low and stay low. However, simula...
  • ShengN_altera's avatar
    ShengN_altera
    3 years ago

    Hi,

    Because you haven't initialize the reg ld_tx_toggle. If you had initialized like this reg ld_tx_toggle = 1'b0; You'll get correct simulation like pic below:

    Thanks,

    Best regards,

    Sheng

    p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer.