Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Timing problems, and calculating max and min input delays...

Hi all... Another day, another problem... Before I start I should say that I am using the FTDI Morph-IC-II board, which has a Cyclone II EP2C5F256C8 FPGA and an FT2232H Usb bridge, Quart...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

You were right I did have the RFB set wrong, as it was still on the falling edge default, but correcting that has not changed the fact that I am losing some bytes of data....grrr

how would I go about sending you the qar file... do PM messages allow attachments? sorry I am still relatively new to the forums!

Cheers