Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
10 years ago

Stand alone signal tap

I would like to run Signal Tap on a different computer than I used to develop the firmware.

  1. How do I obtain a stand alone version of Signal Tap and load it onto my computer?

  2. The design was done using Quarts 10.1 for a Cyclone II device.

  3. Do I need to use Signal Tap 10?

  4. Do I need to use a version of Signal Tap tat supports Cyclone II?

5 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    The computer that I want to run signal tap on runs Windows 7

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    Just download the Quartus programmer seperately and install on the 2nd machine. It's free and doesnt require a licence.

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    --- Quote Start ---

    Just download the Quartus programmer seperately and install on the 2nd machine. It's free and doesnt require a licence.

    --- Quote End ---

    Interesting to know this. Thanks lot for sharing the info.
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    I installed Quartus Prime Lite and put a shortcut to quartus.stpw on the desktop.