SignalTap: Start Rapid Recompile to continue

Question

Hi,

Why does the signal tap file not let me change the trigger condition? Every time I change the trigger condition, the signal tap says Start Rapid Recompile to continue. The nodes that I am trying to trigger on are all there. The lock mode is set to "Allow all changes" I am not sure why this occurs.

altera_forum · Answer

If you don't want to recompile it each time you make a change I suggest you change the lock mode to "Allow trigger condition changes only". That way it'll only allow you to make changes that won't make changes to the design, requiring a recompile.

Refer to Quartus' signaltap setup help page (http://quartushelp.altera.com/14.1/mergedprojects/program/ela/ela_tab_setup.htm) for some more detail.

Cheers,

Alex

Forum Discussion

SignalTap: Start Rapid Recompile to continue

1 Reply

Recent Discussions

Timing analysis - long combinational path

QuartusPro 25.3 Crashed after using the Signal Tap Logic Analyzer

Duplicate_hierarchy_depth / duplicate_register

Automatically added negative node for TDS output doesn't work with Agilex 5

Quartus 20.1std compilation fails for Quartus map - Device 10AS057K2F40I1SG