Forum Discussion

hcom's avatar
hcom
Icon for Occasional Contributor rankOccasional Contributor
4 years ago

Signal Tap example from Intel training course always fails timing

I am using Quartus Prime 21.1.0 Build 169 03/24/2021 SC Pro Edition to target a Cyclone 10 GX (10CX085) FPGA. I followed this Intel training course to set up Signal Tap: https://learning.intel.co...
hcom's avatar
hcom
Icon for Occasional Contributor rankOccasional Contributor
4 years ago

@ShengN_Intel I must admit, I am shocked by your suggestion. Of course, I could set timing ignores everywhere in my design and then I would never see any timing errors. But then I also wouldn't be constraining anything, so (without specific justification) this would be an incredibly bad thing to do.

ShengN_altera's avatar
ShengN_altera
Icon for Super Contributor rankSuper Contributor
4 years ago

Hi @hcom ,

Due to this thread is opened for too long time and no response from you for quite some time, so I had closed pending this thread.

You may open a new thread on this topic and I will pick up the new one when it comes in.

I will reflect this to internal engineering and come back to you in new thread if there is any feedback from them.

Thanks,
Best regards,
Sheng