Forum Discussion
NYup
New Contributor
New ContributorSecure Jtag on Max 10 ---
JTAG Secure mode Hello guys, I'm looking for more information regarding the JTAG Secure mode. It's mentioned a little in the MAX10 Configuration Guide: https://www.altera.com/en_us/pdfs/literature...
YuanLi_S_Intel
Regular Contributor
Regular ContributorHi Nhu-Ha Yup,
There is no switch to change your device in JTAG Secure Mode. You will need to enable the mode in Quartus, compile and generate a POF bitstream.
Enabling JTAG Secure Mode will cause your device to be able to use the instruction as shown at table below:
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf (Page 23)
Thank You.
